Installation Requirements for the CocoonsRoom Equipment is designed for use in indoor conditions. The temperature of the room where the equipment is used should be between 5°C-40°C and the relative humidity of the room should not exceed 85 %. As in the working regime the machine creates humidity, be sure that the construction of the room is moisture proof and the room has ventilation. It is recommended to have a general trap on the floor. It is important that after installation there will be adequate room for the cover of the equipment to be easily opened as there must be sufficient room during the service maintenance. Power The electrical installation of NeoQi® Harmony equipment should be carried out by qualified specialists or official representatives of NeoQi® AS. Power cord should be protected with the protective switch which is in accordance with requirements (CEI 64-8). Power cord material should be at least 3x2,5 mm² copper crosscut wire. The Power cord should be connected without intermediate connections to the moisture proof junction box on the wall close to the equipment. Maximum combined power consumption for the equipment is 3-4,5 kW depending upon the product. The protective device current in front of equipment feeder is 16-20 A. Water Clean water is important for the normal functioning of the equipment. If the rust and mineral matter consistency in the water is too high, then it is advisable to install water filters. The recommended water pressure is 2-4 Bars. 2 water pressure hoses are required, one for hot another for cold water. The len Hinnatud kodulehtede tegemine professionaalne kodulehe valmistamine tunnustatud ja visuaalselt heal tasemel .. korraliku ja atraktiivse kodulehe tegemine aga ka kasutajasõbralike ning lihtsalt kasutatavate kodulehtede valmistamine originaalse visuaaldisainiga kodulehekülje tegemine vaata lisaks ka Tõlketeenused kiirelt ja alati tähtajaks valmis